November 03
20mm2 extruder axis, the direction of rotation of the multistage tandem HAITORUKU specifications and formula (standard equipment), compare gear box
(Image: pink front HAITORUKUTAIPU)
Department Thrust, the standard method SURASUTOBEARINGU multistage tandem type of aircraft compared with body size gear case
1 / 2 below.
Is, of course, between the two axes of the shaft so limited in size and gear shaft bearings in each is limited.
Small two-axis rotational direction of extrusion HAITORUKU the low-speed gear box of high turnover and a strong torque
TASHIMASU.
Since there are no gear shaft, helical gears SUPAGIA items from the standard to move to the back of the device to change
Last inner diameter of the structure and the outside diameter of the tapered shape of the taper and repulsion using食込MI
Structure.
Tip of the screw into the inside of the coupling strength and lose FURE.
If a barrel mounted on the console, the lower tip of φ20mm × 3 to place a line installed in the shaft positioning
. Standard equipment of the barrel between the spacer and gearbox and mounted in the positioning, but
HAITORUKU specifications of the space is about 50mm.
100 (W) × 270 (D) × 150 (H) Overall length from the tip of the input shaft attached to the shaft tip.
October 21st
Mirror screw machining
The process of cutting and processing from the mirror, without distortion, and Darre Edge is available in a simple jig.
Material: SACM645 (nitride steel) nitriding process: HRc 60 or more nitride layers: 0.3mm or more
Turn this way, the mold and die T CHUBUDAI and can be applied to a complex shape.
October 24, with mail Us
Thank you for reference materials and images. Mi-do by hand is a kid, so I think you know that even if the processing引目is vertical to the cutting surface and polished along the direction of the next Call polish. Repeat the process with vertical and horizontal extent of # 400 will finish this work is to shorten the time in question is what to do.
MC processing of the images for reference, so instead of end mills crush the surface will have a good process. Since cutting costs from the impact of a machine that does not bother with the NC program that can take it.
The problem is the pin-tool plant at the tip of CADEAU R (0.5 to a minimum R) is dedicated to impossible because the oil is needed.
E-mail contact, please contact the case.
E-mail contact on November 1 of the cases (machining center remodeling)
MC is dedicated to improve the reshuffle, polished parts and the accuracy of the information depends on the shape of any helpful. Holders of the cutting tool is mounted is Mainstream, a flat mirror finish on the easy side table. Is still low in the overseas PUROGUMU machining center dedicated to the polished, is pretty out there.
Please ask for documents that will shape processing. (Modification of the MC and NC-controlled milling machine is a wish-FANUC)
Recent Comments